Many lovers – motorists dream of a cool car. They are dreaming of unprecedented tuning. But not all dreams are embodied in reality. Some do not have enough money to find a good specialist who would make tuning for them. But the question arises – why hire a specialist, if tuning can be done with your own hands? Today we will talk about removing, from a VAZ car, torpedoes. Why are we shooting it? And for many it is very low and interferes with the use of instrument panels. You need to remove it and change it.First, we must turn off the battery. We remove the terminals. Then you need to remove the pad from the steering wheel. To do this, you need to unscrew the nut in the middle. We remove carefully, with knowledge of the matter, since sometimes the steering wheel jumps up and can cause injuries. The steering wheel sits on the slots, you must first remove it from there, and then unscrew the nut.
Next, we turn the screws of fastening the steering column casing. Remove the circuit breaker cladding. Weaken the bolt holding the base of the switches. Then we remove the base, disconnect the wires of the signal and other functions – the wires of the lever of the switch, the washer and the wiper. Most correctly before disconnecting the wires, they are all differently noted. This is done in order not to confuse them during assembly. Also you need not to forget to remove the wires from headlights and turn signals.
Then the handle of the carburetor air damper is removed. It needs to be removed by stretching. Next, we proceed to the removal of various accessories – ashtrays, cigarette lighter, etc. D. This is done using a simple screwdriver. We proceed to the disconnection of the car radio if it is present. We also work with a screwdriver. Next, remove the nut of the speedometer cable. In addition, other additional devices must be disconnected if they were installed. Do not forget about the ignition relay. The mass of the relay is turned off. We go to the main thing. Remove the panel. We turn off the mounts of the mount, including the main screw, the central. He is removed at the end. Only after that the panel is removed. When installing a new panel, the assembly process should be carried out in the reverse order.